Drilling Fluid production with the GlobeCore AVS-150

drilling fluid

GlobeCore's engineers have recently tested the New AVS-150 Vortex Layer Device’s ability to produce High Quality Drilling Fluids.

A special drilling fluid is always used when drilling a well for oil or natural gas. The drilling fluid is usually made immediately before the extraction of the oil or natural gas. The use of a quality drilling fluid resolves many production problems, from filtration and cleaning of the well, to drilling safety issues. Use of a high quality drilling fluid, therefore, is required in any modern drilling operation.

drilling fluid

To make the proper drilling fluid emulsion, GlobeCore engineers used a carbon based composition of diesel, with the density of 835 kg per m³, water, and the following concentration of other components per one cubic meter: 20 liters of Emultal emulsifier, 12 kilograms of organophilic clay, 20 kilograms of limestone and 90 kilograms of salt rock. In other words GlobeCore Engineers produced a high quality, water-based drilling fluid also known as Water Based Fluid (WBF).

When making the WBF solution, GlobeCore Engineers tested the fluid with a viscometer for plastic viscosity and with a filter press for filtration and crusting at 7 atmospheres of pressure for 30 minutes. Lastly the fluids were tested for density and electrical stability.

Test results

We received the following results:
Plastic viscosity, cPs PV – 11 (centipoise);
Filtration, cm3 Фani – 3,8 (cm³);
Electrical stability, V – 429;
Density, kg/m³ – 940.
The production rate of the AVS-150 is 2 to 2.5 m³/hour.

GlobeCore

LEAVE A MESSAGE


Please fill this line so we can call out to you by name

Please fill this line so we can answer your questions

Please fill this line so we can call you back